DX Commander is a family-run business based in the Midlands.

  • Loki runs the whole build, order management and dispatch processes as well as some small production processes, for instance tapping the 6mm holes in aluminium plates.
  • Gina prepares all the accessory bags that includes all the fork connectors, nuts, bolts, washers and a gazillion little bits!
  • Wendy does all the book-keeping, ordering and payments.
  • Callum deals with technical queries, runs the social media, he makes the company’s YouTube videos and runs all R&D.
  • We ship world-wide with more than 50% of shipments to USA.

We make antennas pimarily for the Amateur Radio (Ham Radio) community.

Visitors BY APPOINTMENT please.

Buy inside the European Union. See this page.

 

 

4.9
Based on 31 reviews
5 star
97
97%
4 star
0%
3 star
3
3%
2 star
0%
1 star
0%

Customer Images

Image #1 from rene petrus vertommen
Image #1 from Sarah
Image #1 from Mark Roberts
Image #1 from Anthony Smith
Image #1 from Anthony Smith
Image #1 from norman maslin
Image #2 from norman maslin
Image #3 from norman maslin
Image #4 from norman maslin
Image #1 from rene petrus vertommen

rene petrus vertommen

Very good for my spiderbeam pole muth bether as the clamp from siderbeam

(0) (0)
Image #1 from Sarah

Sarah

After looking at many options, I think this is the absolute best quality and value. Used for antenna purposes.

(1) (0)
Image #1 from Mark Roberts

Mark Roberts

My original pole broke off, and left me with 5 meters of the lower sections. I am using it as needed. However, the new pole is now supporting a Delta Loop made with some DX10 wire and an LDG 4:1 UnUn. I have it in a triangle configuration, and fed in the corner using RG8X coax. This allowed me to make a CW DX contact to New Zealand on 17 meters! Your products are great and I have documented my test results and posted them on our ARC W5IAS Facebook page. There is one improvement that could be made at the tip of the pole, and that is the eyelet. The diameter should be larger to allow more freedom of movement for wire antenna systems like the Delta Loop. I'm using a short piece of 550 paracord. The paracord isn't as slick to allow the dx10 wire to slide a little when the wind moves it, or during set up. This puts a great deal of stress on the pole below the tip sections.

(0) (0)
Image #1 from Anthony Smith

Anthony Smith

Again as per last comment it took Crackhead to break the pole. The pole was faded from a few summers but still fine. The white Perspex disks are a bit crazed As you can see after years of Queensland climate the parts are still in workable condition. I may buy some replacement disks in a few months however.

(0) (0)
Image #1 from Anthony Smith

Anthony Smith

Excellent quality. My old DX Commander has survived in the Queensland elements for over a few years, rain, Qld tropical thunderstorms, excessive heat in summer, a flood (literally) and it still performed flawlessly. It took our Belgian Malinois 'Crackhead' to run into it when he had zoomies to finally bring it down. They don't call these dogs Malligators for nothing!

(0) (0)
Image #1 from norman maslin

norman maslin

I got 20 of these clips and so far they have done the job of holding up my 2 12mt spiderpoles. The clips look very well made and are easy to use.

(0) (0)
Image #2 from norman maslin

norman maslin

I got 20 of these clips and so far they have done the job of holding up my 2 12mt spiderpoles. The clips look very well made and are easy to use.

(0) (0)
Image #3 from norman maslin

norman maslin

I got 20 of these clips and so far they have done the job of holding up my 2 12mt spiderpoles. The clips look very well made and are easy to use.

(0) (0)
Image #4 from norman maslin

norman maslin

I got 20 of these clips and so far they have done the job of holding up my 2 12mt spiderpoles. The clips look very well made and are easy to use.

(0) (0)
Image #1 from rene petrus vertommen
Image #1 from Sarah
Image #1 from Mark Roberts
Image #1 from Anthony Smith
Image #1 from Anthony Smith
Image #1 from norman maslin
Image #2 from norman maslin
Image #3 from norman maslin
Image #4 from norman maslin
1-5 of 30 reviews
  1. SK

    Purchased the classic 10m to take away on holiday so I could throw up an inverted V at our holiday lodge. A great quality product which does exactly what it says on the “Tin”! Easy to erect, support and secure so I was on air within minutes, and not even the northern Scottish winds bothered it, cheers Callum 😃👍🏻

    (0) (0)
  2. IM

    Item promptly received.

    (0) (0)
  3. DP

    Excellent product with fast shipping.

    (0) (0)
  4. AJ

    The DX10 Wire performs as expected, Very quick delivery, cannot fault the great service. Thank You

    (0) (0)
  5. K
    (0) (0)